The two-step bottle-blowing machine can blow mineral water bottles, carbonated beverage bottles, oil bottles, and other products. Below, Ouge Machinery will explain the routine maintenance and upkeep of the bottle-blowing machine to you. I hope it can help you. If you have other questions, you can also call us.
1. No material is added to the feeding position: Several situations need to be checked.
Is there no material in the hopper? If yes, the preform needs to be poured in. If not: Please check whether the hydraulic bottle blowing machine control contactor is in the energized state. If it is in the energized state, quickly check whether the motor is in the energized and loaded state, because this situation is likely to be caused by the preform (embryo) stuck in the lifting belt. At this time, the easiest way is to help lift it manually. If the hydraulic bottle-blowing machine control contactor is not in the energized state, please check whether the performance detection electric eye is not in the same straight line as the reflector.
2. The feed is stuck in the feed tray: This situation is a headache. From experience, if the preform (embryo) length is longer and the weight is heavier, then this phenomenon is relatively rare.
3. The bottle cannot be taken out of the mold after it is blown.
First, you should open the mold, open and close the mold manually, if it is normal, run it in the idle state, if it is also normal. Please check your exhaust time setting. If the exhaust setting is normal and fails every time you blow a bottle, then it can be judged that it is a problem with the exhaust valve. Please open the exhaust valve to check its spring and seal (another phenomenon of this failure is that the exhaust sound is relatively loud or there is a sound of incomplete exhaust).
If you encounter a situation where many molds are produced normally but occasionally cannot open the mold, please check whether there are broken screws in the locking pin. In addition, please check whether the locking force is too large. It should be readjusted according to the standard if it is too large.
4. The bottle is always pinched
Is the position of the robot misaligned?
5. The two robots collide
In this case, the robot needs to be manually reset, which is caused by misalignment.